110 Lee St Baltimore, MD 21201-2421

Description: Use premises as a single family dwelling

Description: Reinstatement(original permit:com2015-29740:wire 2 bedroom rehab with 2.5 bathroom. relocate existing 200 amp panel 2nd floor and 18 ckts and phone jacks and cable jacks (6 low voltage total). as per code.)

Description: Reinstatement(original permit:com2015-23295:installation of two 90% efficient 54,000 btu gas furnaces. installation of two central air conditioner 24,000 btu. installation of ductwork to condition the house. gas and electric by others. work done to code. )

Description: Reinstatement(original permit:com2015-23361:replace water and drain lines. install (3) toilets, (3) sinks, (2) showers, (1) kitchen sink, (1) washer hookup and (1) electric hot water heater. run gas lne for (2) 500,000 btu furnace and 40,000 btu stove as per code. * hvac by others *)

Description: * notice to proceed * replace existing rear 2nd floor deck (10' 3" wide and 4' 5/8" deep) with a new covered wood porch with dimensions of 12' wide and 8' deep. the porch will have a side gabled roof that matches the pitch of the existing roof on the house, and which will be 12' and 8' deep. the roof will be clad with gaf sovereign shingles in charcoal. all work to be completed as per plans in chap files.

Description: Original permit description:(com2015-14418) addition - building addition on west side of home approx (8' x 7') - powder room 1st floor and 2nd floor addition (7'4" x 11') powder room. framing (2' x 8" 16 oc). *notice to proceed* remove sliding galss door on rear elevation, replace with a single door with one light galss panel (with no grilles between the glass), and clad infilled wall with 3-coat stucco to match existing in strength, composition, color, texture, and finish. remove door and replace window with an impervia sliding window on side elevation, and infill using brick that matches the existing brick in pattern and profile, as well as color, size, texture. tooth new brick into existing, and match mortar joints in color, texture, hardness, joint size, and profile. addition to be clad with 3-coat stucco, a 1/1 wood windows, and a flat rubber roof. all work to be completed as per plans in chap files dated 4/3/15. construct a rear addition on the first and second floors.

Description: Wire 2 bedroom rehab with 2.5 bathroom. relocate existing 200 amp panel 2nd floor and 18 ckts and phone jacks and cable jacks (6 low voltage total). as per code.

Description: Replace water and drain lines. install (3) toilets, (3) sinks, (2) showers, (1) kitchen sink, (1) washer hookup and (1) electric hot water heater. run gas lne for (2) 500,000 btu furnace and 40,000 btu stove as per code. * hvac by others

Description: Installation of two 90% efficient 54,000 btu gas furnaces. installation of two central air conditioner 24,000 btu. installation of ductwork to condition the house. gas and electric by others. work done to code.

Description: Addition - building addition on west side of home approx (8' x 7') - powder room 1st floor and 2nd floor addition (7'4" x 11') powder room. framing (2' x 8" 16 oc). *notice to proceed* remove sliding galss door on rear elevation, replace with a single door with one light galss panel (with no grilles between the glass), and clad infilled wall with 3-coat stucco to match existing in strength, composition, color, texture, and finish. remove door and replace window with an impervia sliding window on side elevation, and infill using brick that matches the existing brick in pattern and profile, as well as color, size, texture. tooth new brick into existing, and match mortar joints in color, texture, hardness, joint size, and profile. addition to be clad with 3-coat stucco, a 1/1 wood windows, and a flat rubber roof. all work to be completed as per plans in chap files dated 4/3/15. construct a rear addition on the first and second floors.